Guides

How to Train Counter Staff on a Loyalty Program in 15 Minutes

By , founder of Stridec · Updated

In short You can train counter staff on a points program in 15 minutes if you teach only three things: say the ask, add points, redeem points. Spend most of the time on practice, because in a Washington University study students who were tested recalled 56% of a passage after a week against 42% for those who re-read it (Roediger and Karpicke, 2006). Repeat the same 15 minutes for every new hire, since food service loses staff constantly.

How long does it take to train staff on a loyalty program?

Fifteen minutes, if the program is simple enough that staff need to learn only three tasks: say the ask, add points, and redeem points. A points-only program makes that possible. Every customer and every staff member already understands spending money and getting something back, so there are no stamp rules, tier levels or voucher exceptions to memorise.

This page is the training plan. It sits alongside how to start a loyalty program in a busy shop, which covers the launch order and the first two weeks, and how to set up a loyalty program in 10 minutes, which covers the setup itself.

Why do you have to train again and again?

Because the people at your counter keep changing. The US Bureau of Labor Statistics tracks this in its Job Openings and Labor Turnover Survey, and accommodation and food services runs well above the private-sector average.

Measure, 2025 annual averageAccommodation and food servicesTotal private
Total separations rate (not seasonally adjusted)5.53.6
Hires rate5.53.6
Total separations, thousands9,30458,675

Source: US Bureau of Labor Statistics, JOLTS Table 20 (separations rates) and Table 19 (separations levels), annual averages for 2024 and 2025, last modified 13 March 2026. The hires rate comes from Table 18. US data. The 2024 separations rate for food services was 5.4.

Your own shop may be steadier or less steady than the US industry average. The practical point is that training cannot be a one-off event before launch. It has to be short enough that you can run it on a new hire’s first shift without dreading it.

What should the 15 minutes cover?

Three tasks, in this order, with time boxed so that most of it goes on practice.

MinutesWhat you do
0 to 3Say what the program is and what the customer gets: points in proportion to what they spend, a reward when they reach it
3 to 5Teach the ask and the poster
5 to 13Practice: each person adds points and redeems on a test member
13 to 15Cover what to do when it goes wrong, then agree who they ask

Keep the explanation to the owner’s own words. If staff can say in one breath what a customer earns and what the reward is, they can answer most questions at the till. If you need help choosing those numbers first, read how to set your points earn rate.

Why spend 8 of the 15 minutes on practice?

Because doing the task from memory sticks better than hearing it again. Roediger and Karpicke at Washington University compared students who re-read a passage with students who took a recall test on it, then tested everyone again after 5 minutes, 2 days or 1 week.

FindingScopeSource
After 5 minutes, re-reading beat testing (81% vs 75% recalled)Experiment 1, 120 undergraduates, prose passagesRoediger and Karpicke, 2006
After 1 week, the tested group recalled 56% against 42% for the re-read groupSame experimentRoediger and Karpicke, 2006
After 1 week, three recall tests gave 61% against 40% for four study sessionsExperiment 2, 180 undergraduatesRoediger and Karpicke, 2006
Students who re-read were more confident they would remember, yet remembered lessBoth experimentsRoediger and Karpicke, 2006

Source: Roediger and Karpicke, Psychological Science, vol. 17, no. 3, 2006, pp. 249 to 255, figures read from the paper text on 20 November 2026.

The subjects were students recalling science passages, not counter staff learning a till task, so treat this as a direction and not a forecast. The direction is clear enough to plan around. Explaining the program a second time feels productive and fades fast. Making each person retrieve the steps themselves is slower to start and holds up better a week later.

In practice, that means no slideshow. Hand each person a phone and a test member and have them do the task while you watch.

What is the ask, and how do you teach it?

The ask is one sentence, the same from every person, said once to every customer at payment. For example: “Want points on this order? Scan this and they’re yours today.”

Teach it like this:

  1. Say it yourself once, at normal speed.
  2. Have each person say it back to you as if you were a customer.
  3. Swap roles. Have one person play a customer who says no, and let the other practise accepting it and moving on.

Why in person? A request made at the counter is the one moment the customer is already paying attention to you. More on getting people to join is in how to get customers to join your loyalty program.

Tell staff plainly that a no is fine. The poster stays up, and the customer may join next visit.

How do staff add and redeem points?

Walk through both on a test member, on the phone each person will actually use at the counter. On Gimify, staff add or redeem points on any phone, and the member card is the QR code that staff scan. There is no new terminal to learn.

Run these two drills:

  • Add points. Each person adds points to the test member for a made-up purchase. Points are earned in proportion to the amount spent, so the drill is also practice at entering the right amount.
  • Redeem. Each person redeems a reward on the test member. The first redemption is when a customer decides whether joining was worth it, so no one should do their first one with a real customer behind them.

If your shop has no POS link, that is fine. A loyalty program without POS integration works because staff enter the purchase themselves, and the drill is where they learn to do it quickly.

What should staff know about mistakes and fraud?

Two minutes, no more. Give them the answers to the four things that go wrong most often:

  • Wrong amount entered. Tell the owner or manager straight away, so it is fixed once and not discovered later.
  • Customer says they joined but staff cannot find them. Ask them to open their member card on their phone, then scan it.
  • Customer asks for points on an old receipt. Staff follow the owner’s rule, which you should set before training and write on the card by the till.
  • A friend asks to use someone else’s points. Staff do not decide this alone. See loyalty fraud at the counter for rules that owners can set so staff are not left to improvise.

Decide each rule yourself before training. Staff should never have to invent policy while a queue waits.

How do you check the training worked?

Use a short check, not a quiz. Before anyone serves a real customer on their own, confirm that they have:

  1. Said the ask aloud, from memory.
  2. Added points to a test member without help.
  3. Redeemed a reward on a test member without help.
  4. Said what a customer earns and what the first reward is.

After a fortnight, count new members and transactions each shift. Divide members by transactions for a sign-up rate. That is the number to improve, and it tells you whether a person needs a second practice or a better sentence. No independent public benchmark tells you what a good rate is for a small shop, so compare your own weeks with each other.

What should the counter card say?

Put a card by the till with four lines and nothing else:

  • The ask, word for word.
  • What a customer earns, in one line.
  • The first reward and what it costs in points.
  • Who to ask when stuck, such as the owner or support@gimify.com.

Take the ask line off the card after about two weeks, once it is routine. Keep the rest for new starters.

What does training look like on Gimify?

On Gimify there is little to teach, which is why 15 minutes works. Customers scan a QR code and enter an email, with no app download or password, and staff add or redeem points on any phone at the counter. The free plan covers one outlet with unlimited members and has no time limit, so you can train the team on a test member before you spend anything.

Questions owners ask

How long does it take to train staff on a loyalty program?

Fifteen minutes is enough when the program is points only. Spend 3 minutes on why, 2 on the ask, 8 on practice with a test member, and 2 on what to do when something goes wrong.

What should staff say to customers about the loyalty program?

One fixed sentence, said once to everyone, that names what the customer gets on this order. For example: Want points on this order? Scan this and they are yours today. Staff should accept a no and move on.

How do I train new hires when staff turn over often?

Make the 15 minutes a standard part of the first shift. Put the three tasks on a card by the till, pair the new hire with someone who has done a redemption, and have them add points to a test member before serving a real customer.

Do part-timers and the owner need training too?

Yes. Everyone who handles payment needs it. A member recognised by one person and met with confusion by another loses trust in the program quickly.

How do I know the training worked?

Count new members and transactions each shift. Members divided by transactions gives a sign-up rate you can compare week to week. Check that every person on shift has completed one add and one redemption on a test member.

What if a customer asks something the staff cannot answer?

Give staff one honest line, such as: I will check and tell you next time. Keep support@gimify.com or the owner's number on the card by the till, and review the question at the end of the shift.

Read next

Start free

Gimify is free for one outlet with unlimited members and no time limit. Unlimited outlets are one flat monthly price.

Start free See plans